JAPAN

ASAHITEC CO., LTD
1 Hinode-cho, Seto,
Aichi 489-0004
Japan
Tel +81 561868616
Fax +81 561869900
E-mail: eigyou@asahitec-j.co.jp
URL: http://www.asahitec-j.co.jp

U.S.A.

ASAHITEC AMERICA CORPORATION
1757 Sheridan st.
Richmond IN 47374
U.S.A
Phone: +1-765-962-8399

Contact Person:

Vice president
Kunitake Ohara
Cellphone: 765-993-6637

Senior Manager
Jeremy Cranfill
Cellphone: 765-914-3050

CHINA　

ASAHITEC CHINA
BaofaRoad, Tianbao Industrial Park,
Baodi District,
Tianjin, China 301800
Phone: +86-22-2252-1196

Contact Person:

Vice president
Kunitake Ohara
Cellphone:
765-993-6637
ohara@asahitec-j.co.jp

Production Manager
Wang Shijie
Cellphone:
86-131-4611-4757

Sales Manager
Yan Hailong
Cellphone:
86-135-2185-5041

TAIWAN

ASAHITEC TAIWAN CO., LTD.
1F 558 Fushin 3rd.,
Hwa-Ya Technology Park Kueishan Hsiang,
Taoyuan Hsien 333
Tel +886-3-211-4815　
Fax +886-3-328-5572

KIWO STENCILGUARD EL

KIWO STENCILGUARD EL « Chemicals for Cleaning « Products « Home

Functional SMD stencil coating – easier cleaning with higher service life

Your advantage – visibly better printing results:
- Optimum print release
- Excellent printing definition
- Fewer misprints
- Less cleaning required
- High solvent resistance
- High abrasion resistance

KIWO STENCILGUARD EL

Stencil tuner for your SMD stencils

Ever smaller assemblies coupled with even smaller apertures in SMD stencils means that SMD electronic producers daily face new challenges in production.

The problem

Any residual paste still sticking to the stencil underside leads to bridge-building between the printed solder paste points on the circuit board and thus to higher rejection rates.

The solution

This is exactly where the innovative KIWO StencilGuard EL stencil coating fits in:

APPLICATION

The clean stencil underside is pre-treated with the special KIWO STENCILCLEAN EL PRIMER (by means of firm cleaning with a saturated cloth). Then the 1-component high performance coating KIWO STENCILGUARD EL COATING is applied. Screw the dosing insert onto the bottle. Squirt the StencilGuard onto the lint-free cleaning cloth supplied and firmly polish. After about 20–30 minutes, this already crosslinks with the stencil material and forms a water and flux repellent protective layer.

Effect

The KIWO StencilGuard EL protective coating is 2–3 nanometres thick and has thus no influence on the material thickness of the SMD stencil. On the contrary, the coating shows high mechanical resistance and is also resistant against common cleaning media – inluding solvents. The coating significantly reduces contamination (e.g. solder balls, flux) sticking on the stencil underside.

Lower cleaning requirements + higher quality = lower process costs.

The practical KIWO StencilGuard EL Setbox contains the primer, the coating components and a dosing insert, as well as lint-free cleaning cloths to do up to 25 SMD stencils.

TECHNICAL INFORMATION

KIWO StencilGuard EL - DE

KIWO StencilGuard EL - EN

DATA SHEET

KIWO StencilGuard EL Coating

KIWO StencilClean EL Primer